ClampTite Tool - a must for every toolkit

We discovered this tool at a recent trade show and were "sold" instantly. This is one of the most versatile, compact repair tools we have ever seen. Its uses are only limited to your imagination. Lose a bolt, it you can thread a thin piece of wire thought the hole, you can secure just about any material to any other material. Simply amazing. One you have tried one, we are betting you are going to want one in every vehicle, motorcycle, RV, boat and toolkit you have. The ClampTite tool is offered in several versions, based on your needs:

Premium Kit $69.95	Deluxe Kit $39.95	Value Kit $29.95
All stainless steel components including stainless steel body with brass nut - corrosion free with easier turning nut for more heavy duty applications	Stainless steel components with aluminum body and wing nut - corrosion resistant with wing nut - the original marine great tool.	Plate steel components with aluminum body and wing nut - for mild environments
Examples:

* Our Clamp Tite Kits include 10 feet of 41 gauge stainless steel wire for your to experiment with or to throw in your tool box you are ready for an instant repair. We have found that practicing a few times will make it much easier to use out on the trail. Rolls of wire are available at an additional cost or you can obtain more wire locally.

CHECK OUT THE REVIEW FROM CYCLE WORLD

What is the ClampTite Tool?

How does it work?

The ClampTite tool give you the option of making either a single wrap or double wrap clamp. Instructions are as follows:

Single Wrap Clamp Instructions		Double Wrap Clamp Instructions
	- Insert end of wire into front pin on the left hand side - Bring wire over the nose and in front of forward pin on the right hand side - Wrap wire around hose (as many wraps as desired - Bring wire over the top of the wraps and around the rear pin on the right hand side - Take wire over the top of the tool and around the pin on the left hand side - Place loop of wire around nose and twist to tighten - Wrap wire around hose (as many wraps as desired) - Bring wire over the top of the wraps and around the rear pin on the right hand side - Take wire over the top of the tool and around the pin on the left hand side - Turn wing nut to tighten		- Cut wire to length (4 times around project plus 12" for tool) - Fold wire in half, tape or wire nut ends together - Wrap around hose where you want a clamp - Tuck ends through the loop
			- Continue to wrap around in the same direction (inside the first wrap) - Tuck thru loop again and remove tape or wire nut - Place tool as shown with wire over front pin and around rear pin - Twist ends together tightly about 6 twists as close to the body of the tool as possible - Place notch at end of tool against the wire loop - Turn wing nut clockwise to tighten (right hand threads)
	- When clamp has reached desired tension, rotate tool 180 degrees to lock clamp - Loosen wing nut and remove clamptite tool - Clip wire ends about 1/4 inch from clam and push down towards hose
			- Rotate tool over to lock the clamp bending wires back over themselves - Loosen wing nut and remove the clamptite tool - Clip off wire ends about 1/4 inch from clamp and push ends down against the hose